Super Sarca Anchor 0.5 (for up to 3.8m Boat)

SARCA No. 0.5 Anchor

Suits Boats up to 3.8 meters
Manufactured in Australia
Hoop on the rear of the anchor ensures that the SUPER SARCA rolls over in most situations, allowing the toe to be in its best possible position to penetrate the ocean floor and reducing dragging as the fluke digs in
No more chain tangled around and between the flukes preventing the anchor from taking hold. SUPER SARCA's unique tangle-resistant design improves anchor efficiency and safety

Unique design also creates a pumping action which sinks the anchor deeper. Teamed with the SUPER SARCA's 360° pivoting action, this makes the SUPER SARCA resistant to wind and tide changes
Incorporates an automatic reset trip release that offers you the highest rate of recovery from rocks. When anchoring in and around bommies, reef or coral the SUPER SARCA has less chance of getting stuck and will create less damage to the environment
Light in weight , easy to handle and contains no lead in the design to contaminate the marine environment
Certified as high holding power anchors by the Victorian Marine Board and MSA witnessed by Loylds of London to comply with the USL code; a testament to their efficiency

How to release

Mud or sand

Come directly above the SARCA and apply light and steady pressure.

The SARCA's special slots allow a break in suction which, couple with a long shank, means the SARCA is easy to free.

Rock or Reef

Simply motor directly above and pull all the slack rope. Then release approximately ½ metre of rope and tie off.

Motor your boat forward over the anchor. This lifts the rear resulting in a high recovering rate.

The moment the anchor releases, the stainless steel D-shackle (not included) slides to the front of the anchors' shank and resets.

Specifications

Boat Length: Up to 3.8m

Boat Weight:200kg

Guide to min length of leader chain: 3m of 8mm

Weight: 3.0kg

Width: 305

Height: 220

Length: 530

A: 125

B: 140

C: 330

(Sarca0-5)

12 Months